2013 Jeep Wrangler Bleed Coolant So get home, jack the front up or park the front on a set of ramps, let it cool. take the rad cap off and start and get to temp, squeeze the top hose a few times wait for level to drop. add antifreeze as needed. let jeep sit over night and do again in the morning. do again in the afternoon if you can or the next night. Cdeslandes. if you have air in your heater core, the easier fix is to disconnect the two heater hoses under the hood, and force feed some coolant through one hose until it overflows from the other, then reconnect the hoses. that should flush the air out. no need to drain the whole system. woo hoo, no more air.
2013 Jeep Wrangler Bleed Coolant Getting that air pocket out of the coolant system can stop over heating and damage. Take the upper radiator hose off the radiator. poor the coolant into the hose at the radiator end. hold it above the bleeder and the radiator. pour it in until its starts coming out of the radiator. no more air. the thermostat housing is a piece of garbage. go get one for 33.00 plus tax or go get a .03 oring. reply like. Easiest way to do this is have a funnel attached to a brass fitting that will screw into the bleed hole. jam the funnel down into the fitting and fill the funnel halfway with coolant. idle the jeep while watching the coolant level in the funnel go down. this has taken me as much as 45 mins to complete. Start the 2013 jeep wrangler with the radiator cap off. one of the easiest ways to bleed your 2013 jeep wrangler 's radiator is to simply remove the radiator cap and then start your engine. leave the vehicle running until it reaches its normal operating temperature. it may take between 15 or 20 minutes before your 2013 jeep wrangler generates.
Comments are closed.