2014 Silverado Fans Running High No Ac No Tempera

2014 silverado fans running high no ac no Temperatur
2014 silverado fans running high no ac no Temperatur

2014 Silverado Fans Running High No Ac No Temperatur I have a 2014 chevy silverado 1500 5.3l that i am having a issue with the cooling fans running on high occasionally. when this happens my temp gauge will read zero and when i kill the engine the fans stay on. the only way to shut them off is to crank the engine and shut it right back off. i have been through two temp sensors and still have the. How to fix the issue on fans high , no ac , no temperature gauge , check engine light on thanks !like , subscribe, follow jg innovation garage llc facebook.

2014 Chevy silverado fan Keeps running
2014 Chevy silverado fan Keeps running

2014 Chevy Silverado Fan Keeps Running Replace the thermostat. replacing the thermostat can be another solution to the problem of chevy silverado fans running. a faulty thermostat can cause the engine to overheat, which in turn can cause the fans to keep running. use a code reader for the diagnosis. the cost of replacing the thermostat can vary. Radiator fan stays on. no a c. asked by almazanmike apr 30, 2020 at 07:41 pm about the 2016 chevrolet silverado 1500 lt 4wd. ok. looked everywhere and can't find anything about this. my radiator fans are all out off whack (simply put). they. run from the time i turn the truck on to the time i shut it off. Anyway, i have a 2014 silverado lt with a 4.3. ac has always been ice cold. today i took it on a road trip about 500 miles and 3 4 of the way there the ac started to get warm then get cold if i got on the throttle. now i have no ac at idle and luke warm at highway speeds. my fans constantly run full speed but turn off as soon as i turn the key off. My 2014 silverado had no reading on temp gauge, fan running high and continuing to run after turned off. took it to car wash oil change place, told them the problem. guy said he had that before. he took off one battery cable, waited 5 minutes (to give it plenty of time to re set) and re attached. problem solved at least for now.

Comments are closed.