2016 F250 6 7 Coolant Drain And Change Ford Truck Enthusiasts Forums

2016 F250 6 7 Coolant Drain And Change Ford Truck Steps to change coolant: 1. look at owners manual for coolant capacity for each coolant system (1 and 2) 2. drain and refill with distilled water. 3. drive around with heater on until the temperature gauge gets close to normal. 4. proceed to drain being careful of hot coolant. 3. 12 26 2004 08:04 pm. 6.7l power stroke diesel 6.7l coolant drain and refill i am going to do the coolant drain and refill on both primary and secondary cooling systems this week after finishing up some mods on my 2012 f 250 6.7l it says to drop passenger front fender liner then shield starter from coolant and remove block drain plug.

Coolant Block Drain Ford Truck Enthusiasts Forums I have a 12. i flushed with the garden hose till clean water flowed through the radiator, heater core, and the cooler underneath the truck. then let it drain till it dripped. fill with distilled, put in 2 qts. cleaner, run for 1 hr. drain and flush with garden hose, flush till clear and no more foam. Install the drain plug when finished and tighten to 60 nm (44 lb ft). remove the waterproof plastic from the starter. release the clamp, disconnect the engine to engine oil cooler hose from the engine oil cooler and drain the coolant from the lh side of the cylinder block. connect the engine to engine oil cooler hose and position the clamp when. This video will show you how to drain and refill the primary and secondary coolant systems on the ford 6.7 powerstroke diesel and also shows you how to drain. Coolant tested fine last year, but looks like 6 years is the time to change per ford. i've read several posts and was going to. 1.) drain system, flush with distilled water and the vc 9 cleaner, drive it for about an hour. 2.) drain again, fill with distilled water, drive it. 3.) drain again and refill with proper ford coolant and distilled water.