3 Easy Steps To Install A Truck Bed Tonneau Cover

3 Easy Steps To Install A Truck Bed Tonneau Cover Step 2: assemble the cover. a hard tonneau cover comes in a vinyl coated metal frame along with screws, nuts and locks. now attach these parts to the truck bed you would like to install. once attached, use some clamps to keep them together. drill holes and install the cover onto its frame, using screws and nuts. Place the tonneau cover assembly on the truck bed according to the manufacturer’s instructions. ensure proper alignment and positioning. attaching the cover rails (side rails) or clamps: install the bed rail or rear clamps provided with the tonneau cover kit. securely fasten the side rail bed rail to the truck bed, ensuring proper fitment.

3 Easy Steps To Install A Truck Bed Tonneau Cover The cover comes with a left and right rails hard folding cover three d shaped cap bumpers, one bulkhead seal, two prop rods, two drain tubes, a construction manual, six clamps, two elevator bolts, and a hardware bag. step 1. install the bulkhead seal. according to the instruction manual, if your truck has a drop in bed liner, the seal isn’t. Take the two knobs with the flat washer on the bolt before doing the same to the lock washer. loosely tighten each knob on the bolt. unfold the cover and adjust it so that it would fit the edge of the tailgate. once the cover is set and aligns properly, unfold the cover again and finish tightening the knob on the bolt. Make sure the end of the rail with the nylon strike is in the rear of the truck bed. at the front of your truck bed, adjust the top of the rail flush with the top of the box and hold it there with assistance of another person or a spring clamp. install the first clamp as close to the front of the bed as possible and use a ½"’ wrench to tighten. 2. open the tailgate. a closed tailgate can interfere with installation. 3. position a side rail loosely onto the bed rail. most tonneau covers come with two side rails, which fit onto the top or side of the truck's bed rails. place a side rail flush with the front of the bed rail, next to the cab.

3 Easy Steps On How To Install A Truck Bed Tonneau Cove Make sure the end of the rail with the nylon strike is in the rear of the truck bed. at the front of your truck bed, adjust the top of the rail flush with the top of the box and hold it there with assistance of another person or a spring clamp. install the first clamp as close to the front of the bed as possible and use a ½"’ wrench to tighten. 2. open the tailgate. a closed tailgate can interfere with installation. 3. position a side rail loosely onto the bed rail. most tonneau covers come with two side rails, which fit onto the top or side of the truck's bed rails. place a side rail flush with the front of the bed rail, next to the cab. 4. install the cover on the truck. place the cover on your truck at the front, behind the cab. for retractable covers, have a second set of hands help you position the cover, since it’s a bulky, heavy box to install. attach the cover to your truck bed using the clamps and hardware provided. close the tonneau cover and check alignment. Align the tonneau cover’s rails and tighten all mounting hardware until it loosely holds the rails in place. re check rail alignment and if ok, fully tighten the mounting hardware. install any tailgate or cab side seals if they were included with your cover. set the top on the tonneau rails and check that the tonneau sits evenly along the.