Acrylic Mold Makes For Professional Looking Silicone Keyboards Hackaday

Acrylic Mold Makes For Professional Looking Silicone Keyboard The build started by milling a two part mold from acrylic. silicone rubber was tinted and degassed before injecting into the mold with a baster. the keys are connected by a thin membrane of. Clamp the mesh with conductive buttons into a mold to inject silicone so the mesh gets encapsulated. won't matter if the silicone doesn't directly bond to the tpu, the mesh will hold them together.

Acrylic Mold Makes For Professional Looking Silicone Keyboards Hackaday Acrylic mold makes for professional looking silicone keyboards february 3, 2020 by dan maloney 17 comments the border between consumer electronics and diy projects is getting harder and harder to. 5.4k subscribers in the hackaday community. hackaday serves up fresh hacks every day from around the internet. read the latest articles from…. The feet for the keyboards are silicone. they aren't particularly special, just custom. here is a picture of the mold for the silicone feet. it's a good quality mold, but it's just made for small scale production. i needed under 100 pieces so there are only 4 cavities in the mold. a production mold might have 100 cavities. The feet for the keyboards are silicone. they aren't particularly special, just custom. here is a picture of the mold for the silicone feet. it's a good quality mold, but it's just made for small scale production. i needed under 100 pieces so there are only 4 cavities in the mold. a production mold might have 100 cavities.