How To Replace N54 Wastegate Flappers 30ff Turbo Fault Diy Youtu Wastegate flapper replacement procedure. time: 2 hours (if it goes smoothly) from a high level, the procedure is: remove the vacuum actuator and clevis. grind the old flapper assembly apart, allowing the flapper to be removed from the turbo. drill out the retaining pin. hammer the old bushing out of the housing. Instructional video to demonstrate the replacement process for wastegate flappers.
Diy N54 Turbo Wastegate Flapper Replacement 5. maneuver the shortened 5mm allen bit into the head of a bolt on the wastegate actuator mount. *tip* it is very very easy to drop this bit. consider a dab of glue thread string fishing line to save yourself some headache if you drop it. 6. use a 1 4" ratcheting wrench to drive the 5mm allen bit. It's hard to beat a good visual inspection. remove the pinch clamp from the downpipe to resonator, remove bolt from exhaust to tranmission. remove 4 nuts securing cat to turbo and slide it back. you should be able to see inside to see if the cat looks like a honeycomb or a smashed honeycomb. Just my $.02. i just did this 3 weeks ago. it was a bit of a paint in the butt to remove everything. i replaced the with turbolab rattle kit. a lot better then it was before. i also replaced all the o rings for piece of mind. all in all it was about 300 dollars. my turbos arent leaking oil and had no shaft play. Vtt n54 waste gate repair kit rattle fix tired of the annoying n54 wastegate rattle? turbos still going strong, but can't deal with the embarrassing rattle anymore? we have the perfect kit for you. this kit comes with 1 set (both turbos) of stainless steel wear matched bushing, and flapper assembly, wastegate arm, rod.
Comments are closed.