Mini Cooper Coolant Change R50 R52 R53 2001 2006 Pelican Parts D For more mini guides & diagnostic tools visit us at diagnostic world. Figure 12 (r50 r52 r53 cooper and cooper s) re connect the lower radiator hose and fill the coolant expansion tank with a 50 50 mixture of antifreeze coolant and distilled water. start the engine and keep an eye on the max min marks on the side of the tank. the coolant level should drop as the engine warms up.
Ignition Coil Location Mini One Cooper S Convertible R50 о Step 4 – refill cooling system. after all of the coolant has drained from the cooling system, proceed with refilling the system. reinstall the lower radiator hose and hose clamp. fill the coolant expansion tank with either pre diluted antifreeze coolant, or a 50 50 mix of distilled water and coolant concentrate. The r52 is the mini convertible model has comes in both “ justa ” trim (naturally aspirated) and the “ s ” supercharged (forced induction). transmissions were similar to those of the r50 and r53 (see above). production years were 2005 through 2008. the “justa” trim had a curb weight of approximately 2568 pounds and the “s” of. 1) carry out the work on the cooling system after cool down. 2) properly dispose of the coolant per local regulations. 3) before ignition off, place the heater control in high heat and the fan on low. 4) remove the pressure relief cap on the expansion tank. 5) remove the under body protection panel. Cooper (r50 and r52) cooper s (r53) john cooper works gp: country location: united kingdom: united kingdom: united kingdom: year of production: 2001 to 2006 – hardtop 2004 to 2008 – convertible: 2001 to 2006 – hardtop 2004 to 2008 – convertible: 2006: layout: transverse front engine, front wheel drive: transverse front engine, front.
Engine Coolant Location Mini One Cooper S Convertible R50 R52 R53 1) carry out the work on the cooling system after cool down. 2) properly dispose of the coolant per local regulations. 3) before ignition off, place the heater control in high heat and the fan on low. 4) remove the pressure relief cap on the expansion tank. 5) remove the under body protection panel. Cooper (r50 and r52) cooper s (r53) john cooper works gp: country location: united kingdom: united kingdom: united kingdom: year of production: 2001 to 2006 – hardtop 2004 to 2008 – convertible: 2001 to 2006 – hardtop 2004 to 2008 – convertible: 2006: layout: transverse front engine, front wheel drive: transverse front engine, front. Step 6 – remove the map sensor (r53 only) locate the map sensor above the thermostat housing. disconnect the map sensor and 02 sensor connectors. you'll need to pull up on the map sensor tab and squeeze the 02 sensor connector tab to unlock them. remove the two screws holding the map sensor to the mounting bracket. Step 2 – remove the front bumper. open the hood and turn the wheel full lock to one side. remove the 8 10 screws at the bottom of the front bumper near the grille using a phillips head screwdriver. remove the two 8mm bolts in each wheel well area near the headlights. you can reach these bolts from the bottom.
Comments are closed.