Hillbilly Wizard 10 Bolt And 14 Bolt Semi Float Youtube Hillbilly wizard describes todays shipment, a gm 10 bolt front and 14 bolt 9.5" semifloat rear axle. these are fully refurbished and custom built!. What we have here is a tough as nails gm 14 bolt full floating axle. first, we started with a tough as nails gm 14 bolt. next, we cured the biggest problem with the 14 bolt with a ballistic fabrication full shave kit. this gives an insane 2 inches of ground clearance over stock. the bottom bolts are countersunk for extra bolt protection.
Cucv Gm 14 Bolt Srw With 4 56 And Detroit Hillbilly Wizard The 14 bolt semi floater and the 10 bolt both are obvisouly semi floating axles. they use c clips to hold the axle shafts in. to be honest, i would never run a semi floating axle again, there are just too many advantages to the full floaters. the 9.5" semi floater is stronger than a 10 bolt, but still not even close to the full floater. Also fits 1988 with 1st design 10.5 inch rear end; does not fit 1988 with 2nd design 10.5 inch rear end; note: ** for 1984 1985 you must use pinion nose bearing dc57524 not packaged in this kit; ring gear bolts in this kit will fit up to 4.10 ratio. if using 4.56 and higher ratio gears you will need rgb10 ring gear bolts; parts. I recently purchased a 14 bolt semi float from a '94 k2500 with the six lug pattern and the perhaps infamous g80 limited slip. i believe the 14 bolt differential version of the g80 has less reports of exploding, and some guys think the g80, if used correctly with appropriately sized tires for your axle, is reliable. However, most people are not aware of the less common six lug, semi floating version of the 14 bolt axle. gm called it the "9.5" 14 bolt (after its ring gear diameter) and offered it exclusively in light duty 3 4 ton pickups built between 1986 and "93. while not as strong as its eight lug cousin, the semi floating 14 bolt rearend does sport.
Comments are closed.