How To Change The Engine Coolant In Your Truck For Summer Duramag With a cold engine, add coolant to the full or cold mark. to get rid of as much air as you can during the fill, squeeze the upper radiator hose to ‘burp’ the system. repeat it a few times until there aren’t any air bubbles heard or felt in the hose. 5. install the cap. Open your hood and locate your radiator and coolant reservoir. some older vehicles don’t include a reservoir, but most modern vehicles have a small tank for filling and checking the coolant level. the reservoir should be clear plastic, so you can easily see the level of coolant and the maximum fill line.
How To Check And Add Antifreeze Or Coolant To Your Vehicle Diy Video 3. check the radiator fluid level by looking at the “fill” line. coolant systems don’t normally have a lot of extra room at the top, so the fluid levels should be near the top. if the fluid is more than a few inches from the cap, it’s probably low. look for the “full” or “fill” line etched into the radiator metal. How to add coolant to your vehicle. to add antifreeze to your car, you must first gather all of your supplies, cool off the engine, and locate the coolant reservoir. once you check the antifreeze levels, you can take off the cap and fill it appropriately. plus, you want to inspect the system to ensure there are no leaks or problems. Turn your engine off and let it cool down for 15 minutes, then pop the hood and locate the coolant reservoir near the engine. uncap the coolant reservoir and use a funnel to add coolant to the reservoir up to the “max” or “fill line” indicators on the side. replace the coolant cap and let the car idle for 5 minutes while you check the. 5. squeeze the bulb of your antifreeze testing tool. this will create a vacuum inside the tester that will suck coolant into the chamber, providing a sample of your vehicle’s coolant to test. 6. stop filling the tester when the amount of liquid fills up to the top of the temperature measurements on the tool. 7.
Comments are closed.