How To Make Cute Walking Robot Simple Diy Robot Youtube How to make the simplest and cutest walking robot on subscribe to my channel at subscription center?add user=mcisectionfollow m. Make a cute and simple walking robot with a gear dc motor powered by a 9v battery. it is a wonderful cute diy toy for kids and very easy to make.note: this v.
How To Make The Cutest Walking Robot On Youtube вђ Artofit Play with mechanical motion through robot building and experimentation to create your own walking robot! #kiwico order a tinker crate now: kiwico. 5) cut a hole approximately 8 mm * 15 mm in the right position on the right side of the cardboard. 6) fix the edge of the cardboard with craft sticks to prevent deformation. 7) paste the appropriate length of the pin header on the right side of the crease, to increase the friction when walking. dfrobot boson is now on kickstarter!. Cut a longer piece of the wooden skewer, and glue it to the center of the first dowel piece at a 90 degree angle as shown. cut a piece of the popsicle stick and glue it to the bottom of the first dowel piece to make a foot. repeat this process to build the second leg, which should be a mirror image of the first leg. Drill the marks that you have just made with a 1 8" drill bit. flip the spatula upside down, and place the other spatula on top of it right side up. align them so they are of matching height. use the first set of drill holes as guides to drill another set of holes in the other spatula.
Awesome Idea 4 Legs Walking Robot How To Make The Cutest Walking Cut a longer piece of the wooden skewer, and glue it to the center of the first dowel piece at a 90 degree angle as shown. cut a piece of the popsicle stick and glue it to the bottom of the first dowel piece to make a foot. repeat this process to build the second leg, which should be a mirror image of the first leg. Drill the marks that you have just made with a 1 8" drill bit. flip the spatula upside down, and place the other spatula on top of it right side up. align them so they are of matching height. use the first set of drill holes as guides to drill another set of holes in the other spatula. Building the legs. the next important step is to build the legs of the walking robot. take the two 5cm sticks and fix the 7.5cm stick as shown below. this structure acts as the base of the leg. now, for the actual leg part of the robot, take the 11cm long stick and fix it to the center of the base structure i.e. center of the 7.5cm stick. Attach the geared dc motor to the 9v battery "foot": attach the second geared dc motor and attach the battery. make sure that it is higher than the first one as shown: attach the battery clip to the 9v batteries then connect the wires following the diagram below. you can solder them or just splice them and apply glue.
Comments are closed.