How To Propagate A Snake Plant So You Can Share It With Friends

how To Propagate A Snake Plant So You Can Share It With Friends
how To Propagate A Snake Plant So You Can Share It With Friends

How To Propagate A Snake Plant So You Can Share It With Friends Water when soil is dry to the touch. how to propagate your houseplants to expand your collection. bhg juli lopez castillo. 2. rooting cuttings in water. rooting snake plant cuttings is as easy as placing a leaf into a jar of clean water. begin by cutting a mature sized leaf off an established plant. place the cut end of the leaf in a jar or. Sterilize a pair of scissors, shears, or a sharp knife (like a hori hori knife). find a larger leaf on the snake plant and cut it close to the base of the plant. make sure the leaf is healthy, otherwise it won’t have a good chance of being viable. allow the cut end of the leaf to callous over, which usually takes a day or two.

how To Propagate A Snake Plant So You Can Share It With Friends
how To Propagate A Snake Plant So You Can Share It With Friends

How To Propagate A Snake Plant So You Can Share It With Friends Step 4: make the cuts. if your snake plant’s leaf is more than two inches wide, then you’ll need some tricky handiwork here. first, cut into the leaf from the highest point you intended to cut from, downwards at a 45 degree angle until you reach the halfway point. repeat on the other side to remove the cutting. Use the sharp craft knife to split the leaf up into sections. cut the leaf into 4 inch sections, marking the top of the cutting on each one to indicate the direction of the root growth. this will stop you from planting the cutting upside down which will prevent any potential root growth and only lead to rotting. Divide the cuttings. cut each leaf into several 3 to 4 inch tall sections. keep track of the top and bottom of each cutting (i.e., the way the original leaf was growing) while dividing the leaf. ensure the bottom of each cutting is placed in the soil because that’s where new roots and growth will start. Propagating cuttings in water. cut off a snake plant leaf with pruning shears, scissors, or a knife. make your cut near the soil, close to the leaf’s base. choose a leaf that’s about 6 inches (15 cm) or more tall and dark green. if the leaf is browning, that’s a sign it’s getting old and shouldn’t be used to propagate.

Comments are closed.