How To Replace A Shutoff Valve Diy Family Handyman

How To Replace A Shutoff Valve Diy Family Handyman Close the new valve. open the water main shutoff valve and let the water run until all the air is out of the pipes. then shut off the upper and lower faucets. check the new valves for leaks. turn the water heater gas valve back to ‘on,’ or flip on the circuit breakers to the electric water heater. step 6. Buy a threaded replacement ball valve; it’s a far better choice than the older gate style valve. screw on the new ball valve, install the old nipple and the new leather washer (use teflon tape or pipe dope on the threads). tighten the coupling nut, turn on the water and check for leaks. step 4.

How To Replace A Shutoff Valve Diy Family Handyman Tighten the packing nut. tighten the packing nut on the toilet shutoff valve one eighth turn clockwise to try to seal a leak around the nut. pro tip: wrap cloth or masking tape on the plier’s jaws to protect the nut’s finish. use light, steady pressure so you don’t damage the water lines. step 2. Here’s how. first shut off the water to the leaking water valve. next remove the handle from the stem and then loosen and remove the packing nut. remove the old washer and slide on the new one. reinstall the packing nut, tighten lightly with a wrench (don’t over tighten at this or any other point) and reattach the handle. Fix a leaking shutoff valve and save yourself the cost of a visit from the plumber. expert tips for an easy faucet installation we caught up with joe barnes, a second generation master plumber with more than 30 years of experience, to tackle. Hold the rag over the area for a minute or two, and then carefully open the gap a little larger so you'll have more room for the sealer. squeeze seam sealer (white glue works in a pinch) into the gap, and press the paper to the wall with a roller. clean off the excess sealer with a sponge. 20 99. family handyman.

How To Replace A Shutoff Valve Diy Family Handyman Fix a leaking shutoff valve and save yourself the cost of a visit from the plumber. expert tips for an easy faucet installation we caught up with joe barnes, a second generation master plumber with more than 30 years of experience, to tackle. Hold the rag over the area for a minute or two, and then carefully open the gap a little larger so you'll have more room for the sealer. squeeze seam sealer (white glue works in a pinch) into the gap, and press the paper to the wall with a roller. clean off the excess sealer with a sponge. 20 99. family handyman. Use the plastic spanner cap or the tips of needle nose pliers to rotate the cartridge. slide the brass clip into the slots in the valve body to hold the cartridge in place. look for the small notch on top of the stem and rotate the stem until the notch faces you. install the remaining parts and reattach the handle. Connect the supply tube to the supply lines. clean the copper tubing with fine sandpaper. then slip the nut, compression ring and valve body over the pipe and tighten. close the valve, turn on the main water valve and check for leaks. place a bucket under the faucet and turn the faucet on to check for leaks.