How To Replace Maf And Map Sensors In A Chevy Colorado Youtube A short video showing how to replace the maf (mass air flow) and map (manifold absolute pressure) sensors in a 1st generation chevy colorado. these sensors. Buy now!new map sensor from 1aauto 1aau.to ib 1aemp00010the manifold absolute pressure (map) sensor measures the air coming into your fuel injecte.
How To Replace Map Sensor Chevy Colorado Youtube How to: maf sensor cleaning replacement. this video was made by special request for @dataxman cheers buddy! i was able to set some time aside today to film and edit it all in one go. enjoy. thanks for watching. appreciate it! thats exactly how i clean mine and did when i had my 2007 canyon. Maf (g s) 12.29. tps 32.9%. i then did live data in the driveway sitting cold. map (kpa) 36. iat 25 c. maf (g s) 5.78. tps 35.7%. the thing that caught my attention was the tps value with no foot on the pedal. i used my scan tool and eased into the pedal to check for a bad spot over the entire range and there was none. **check out the tools we used below. if the video was helpful, please give it a "thumbs up" and consider subscribing to the channel.**this video goes over ho. Step 2.1: locate map sensor (see pictures) and remove the electrical connector (pull the red tab towards the front of the truck, then push down on the black tab while pulling the body of the connector towards the front of the truck. see picture below) . step 2.2: use an e10 socket to remove the bolt. step 2.3: remove map sensor by pulling up on it.
Comments are closed.