How To Replace Shark Rotator Brush Roll At Donna Devito Blog Remove the 13 screws (circled in yellow) using a phillips screwdriver. be sure to keep track of which screws go into which hole. remove the one screw (circled in red) that has a torx head (might be phillips head on some models). the torx screw is hidden under a rubber gasket. carefully, lift up the gasket without damaging it to access this screw. Locate the bottom plate of the vacuum, which typically has screws or clips holding it in place. remove the screws or release the clips to detach the bottom plate. 3. access the roller brush. once the bottom plate is removed, you will have access to the roller brush. it is usually held by a belt or a series of screws. 4.
How To Replace Shark Rotator Brush Roll At Donna Devito Blog Go to step 1. the roller brush can have debris that will cause the vacuum to not work properly. it is important that you always clean your roller brush after every use, so that your shark rotator powered lift away speed vacuum can perform at it's best. this guide will show you how to change your roller brush if it becomes damaged or is broken. Overview of the steps involved in replacing the brush roll of a shark navigator vacuum cleaner. vacuum repair.paid links: as an amazon associate, i earn from. Then, locate the brush roll cover, which is usually located on the top or bottom of the vacuum head. use a screwdriver to remove the screws holding the cover in place. once the cover is removed, you will see the roller brush. carefully lift the brush out of its housing and pull it straight out. take note of how the brush is positioned so you. Step 5: re attach the roller brush and replace the cover. once you have cleaned the shark lift away vacuum roller brush, re attach it back to its housing and secure it in place. next, slide the brush cover back into the vacuum cleaner. you should hear a clicking sound to confirm that the cover is in place.
Comments are closed.