How To Replace Shocks 12 Steps With Pictures Wikihow As the shock absorbs bounce, the fluid contacts the gas, causing resistance and dampening the spring action. 4. jack your vehicle in an appropriate location. [6] park your car on a level surface and loosen the lug nuts on both sides of the front or back end. secure your vehicle with ramps and or jack stands. Make a note of the strut top plate rotation before removal and reinstall in the same position. the strut can now be removed from the spring while the spring is still compressed by the spring compressor. check the top plate bearing if it needs to be replaced. 5. assemble the new strut. put the new strut into the spring.
How To Replace Shocks 12 Steps With Pictures Wikihow 1. pull the cotter pin and loosen the large castellated nut. the top should look like a crown, or castle, at the bottom. leave the castellated nut in place, just a few turns in to keep it in a safe place. [4] if you’re working on a mcpherson strut suspension remove the “pinch bolt” that clamps the ball joint stud. 2. 1. remove the vehicle’s hubcap. before so much as jacking up the vehicle, you need to remove the axle nut. start by removing the hubcap for the respective wheel of the cv axle to be replaced. for vehicles with rims, you may simply have a cap at the center of the wheel rather than a hubcap. 2. Insert the tool between the ball joint of the outer tie rod end and the steering knuckle. use it to pry the shaft out of the steering knuckle. 6. remove the outer tie rod end from the inner tie rod end. to do this, you will twist the outer tie rod end off of the spindle of the inner tie rod end. Push your vehicle down in one of the corners. if it bounces excessively, your shock absorbers are worn. 2. buy new sport shocks immediately if your car acts up while driving. if your car starts to show warning signs while driving, you should get your shock absorbers replaced immediately.
How To Replace Shocks 12 Steps With Pictures Wikihow Insert the tool between the ball joint of the outer tie rod end and the steering knuckle. use it to pry the shaft out of the steering knuckle. 6. remove the outer tie rod end from the inner tie rod end. to do this, you will twist the outer tie rod end off of the spindle of the inner tie rod end. Push your vehicle down in one of the corners. if it bounces excessively, your shock absorbers are worn. 2. buy new sport shocks immediately if your car acts up while driving. if your car starts to show warning signs while driving, you should get your shock absorbers replaced immediately. 1. remove the clot from a massive pe (pulmonary embolism). [10] if a pulmonary embolism is confirmed as the cause of obstructive shock, it is key to have this treated as soon as possible. sometimes a "thrombolytic" (clot busting) drug can be considered to treat a large pulmonary embolism. 1. park on a level surface in a secure area and turn off your vehicle. avoid changing your battery on the side of the road when at all possible. find a safe place to work that’s well away from traffic, sparks, open flames, or water. engage your parking brake and turn your vehicle off.
Comments are closed.