How To Reset Honda Civic Tpms Low Tire Pressure Light 2019 2020 Set your tire pressure with an accurate gauge. turn the car to the on position. press and hold the tpms switch on the dash to the left of the steering wheel for 3 seconds. when the calibration successfully begins, the tpms light on the dash blinks twice. drive the car 26 mph or faster in a straight line and verify the light goes out. How to reset the (tpms) tire pressure monitor system on a 2019 honda civic.
2020 Honda Civic Reset Tire Pressure Light To reset tpms on your honda civic 2019, follow these simple steps. start by locating the tpms button, usually found under the steering wheel. press and hold the button until the tpms light blinks twice, then release. next, drive your honda civic at a speed of 50 mph for about 10 minutes to allow the tpms system to recalibrate. How to reset tire pressure light on a honda civic. Turn on the ignition without starting the engine. press and hold the tpms button until the tpms indicator blinks twice. drive your vehicle for at least 20 minutes at a speed of 30 mph or more. stop your vehicle and turn off the ignition. start the engine again and check if the tire pressure indicator light is off. Inflate all tires to the pressure listed on the vehicle placard. 2. select obd ii (perform relearn using tpms scan tool) from your tool’s menu. 3. starting with the lf tire, use your tool to scan each sensor in the following order: lf, rf, rr, lr (and full size spare if equipped). 4.
Comments are closed.