How To Wire A Thermostat Explained With Diagram R or rc wire (power) connected to the r power terminal to power the thermostat. w wire (heat), connected to the heating control. g wire (fan) connected to the fan control to operate a blower in your hvac system. y1 wire (cooling) connected to the y terminal compressor refrigerant system. Basic thermostat wiring diagram explained. in this video i go over the basic wiring schematic of a home thermostat for furnace or air conditioner application.
Thermostat Wiring Explained Here’s how to wire a thermostat using the color code and, fyi, each terminal’s purpose. attach the red wire to the r terminal (call for heating and or cooling). attach the green wire to the g terminal (fan). attach the white wire to the w terminal (heat). attach the yellow wire to the y terminal (ac). Use the screwdriver to remove the two wires from the terminals. remove the old thermostat’s motherboard and replace it with that of the new thermostat. reconnect both the red and white wires and tighten the screws. return the control panel to its position and turn the furnace on to test the wiring. Unscrew the two wires from the terminals. remove the motherboard of the old 2 wire thermostat and put the new 2 wire thermostat in its place. reconnect the red and white wire, tighten down the set screw, and put the control panel back on. test the 2 wire thermostat wiring by turning the furnace on. Connect the new thermostat. place the plate of your new thermostat against the wall where it will be located. check the plate with a level, and mark the screw holes with your pencil. if applicable, drill guide holes before adding anchors to the wall. pull the wires through the opening of the thermostat’s backplate.
Thermostat Wires Explained Unscrew the two wires from the terminals. remove the motherboard of the old 2 wire thermostat and put the new 2 wire thermostat in its place. reconnect the red and white wire, tighten down the set screw, and put the control panel back on. test the 2 wire thermostat wiring by turning the furnace on. Connect the new thermostat. place the plate of your new thermostat against the wall where it will be located. check the plate with a level, and mark the screw holes with your pencil. if applicable, drill guide holes before adding anchors to the wall. pull the wires through the opening of the thermostat’s backplate. Disconnect the wires. once you’ve located all the wires, taken a photo, and labeled where everything goes, it’s time to disconnect the wires and the mounting screws. make sure to tape the wires down so they don’t fall inside the wall. remove any anchor screws and the backplate of the existing thermostat. Basic thermostat wiring for furnace and air conditioner. i show where the wires go at the thermostat, the color code, then down at the furnace control board,.
Comments are closed.