Toyota Mr2 Cooling System To bleed the cooling system, there are two bleeder valves that need to be opened. they are both located in the front trunk. one is on the radiator (driver’s side), and the other is on the heater core. after removing the plastic covers, the radiator bleeder can be seen. the heater core bleeder is shown in the following pictures. There are 2 diagrams that cover the whole engine cooling system and 1 for the heater system. being that your car is canadian there should only be 1 type for your car in each diagram. in japan there were at least 4 different types depending on year and engine. 1990 jdm sw20 mr2 g limited. gen4 3sgte swapped.
Coolant Flush Toyota Mr2 Graysgarage Ca At Gray S Garage Engine still won't bleed. yes the rivot is at 12pm and car has spent days in various positions of the ass end in the air. get about 2.25 gallons of coolant in it each time, maybe 2.5. there is air somewhere in the sytem. yes drained it out completely for a 1 2 of a day at the radiator and bolts under the car. Connect your bleeder lines and open the bleeders and elevate (i used a piece of wire to tie them to the top of the frunk so they were elevated). start the car and let it idle. turn the heater all the way to hot. as it heats up, the air will be inherently moved up and it will bubble out. 4age cooling system 101. the water pump pumps water into the block, it circulates into the head and comes out of the head on the passenger side above the water pump. the water travels passed the cap and forward to the radiator, entering at the top. the water comes out the bottom of the radiator and travels rearward to the thermostat housing. Page 6 eg1–423 3s–gte engine – cooling system (i) fill coolant into the reservoir tank up to the ”full” line. (m) check coolant for leaks. 6. reinstall upper radiator support seal (a) temporarily install the hood lock with the rh side bolt. (b) place the support seal in position. view and download toyota mr2 sw 1993 manual online.
Comments are closed.