Omc Cobra Water Pump Kit Step By Step Installation Photos K push water pump case in and turn 1 4 turn clock wise at the same time. l line up holes. l line up holes. m place anti seize compound. place anti seize compound. n torque bolts to 10 ft lbs. torque bolts to 10 ft lbs. o line up holes. use small screwdriver to help line up holes. Omc cobra water pump removal and installation with instructions, tools, loctite compound. step by step illustrations and procedural steps to repair w.
Omc Cobra Water Pump Kit Step By Step Installation Photos Remove the three 5 16 inch x 2 inch long bolts from the housing. remove water pump tube from case. remove the tube by cutting the tie strip and pulling tube from the housing. you do not need to remove lower end of vent tube from the upper gear case. case and impeller. this is what a good impeller should look like. Follow these steps to install the new water pump: 1. prepare the new water pump: before installation, inspect the new water pump to ensure it is the correct replacement for your specific omc cobra model. make sure all the necessary components, such as gaskets and seals, are included in the new water pump kit. 2. Cadet. i have a 1991 5.8 liter omc engine with a cobra outdrive. the engine is over heating and i have narrowed it down to lack of good water flow from the outdrive. when i put the garden hose on the outdrive the engine runs nicely at 160 degrees. when i run it in the water, the engine quickly heats up to 200 degrees. Omc cobra water pump kit with housing. includes: impeller, water pump housing, water pump housing liner, ss wear plate, gasket and "o"ring. replaces: omc 984461 0984744, sierra 18 3348, and emp 46 03638.
Comments are closed.