Bravo One Xr Sterndrive Outdrive By Mercury Racing New 2022 Py 12 195 Outdrive sterndrive maintenance. add comment. powerboat televison. 393 views. 1 min read. watch later remove cinema mode. home » outdrive sterndrive maintenance. Servicing the gimbal ring and transom assembly is done by retorquing the steering and hinge pins. make sure the servicing dealer inspects all bellows, u joints and splines; lubricates all grease points; and replaces any worn parts. a good indicator of a loosened hinge pin is the failure of the trim limit or trim sending system on your boat.
Outdrive Sterndrive Maintenance Powerboattv Ensuring that the routine maintenance and service items are done on your sterndrive ensures its long life, reliability and efficiency. on this myboat diy, mi. During our visit to mercury marine canada, jerry sims walks us through some of the maintenance requirements for a typical sterndrive and reminds us why this. A small amount of time spent maintaining boats will return optimum performance, increased longevity, and greatly reduced expenses over the life of the boat. maintenance procedures aimed at prevention of wear on the engine and stern drive involve inspection, cleaning, lubrication, and adjustment. this is a general guideline for maintaining your. Lubricate sterndrive and replace o rings (click to expand) frequency: every 100 hours. materials needed: bravo installation kit (16755q1), engine coupler spline grease (92 802869a1), u joint and gimbal bearing grease (92 802870a1), 2 4 c marine lubricant (92 802859a1), special lubricant 101 (92 802865a1) tools needed: rags; wire brush; grease.
Getting Your Boat Ready For Spring Outdrive Sterndrive Maintenance A small amount of time spent maintaining boats will return optimum performance, increased longevity, and greatly reduced expenses over the life of the boat. maintenance procedures aimed at prevention of wear on the engine and stern drive involve inspection, cleaning, lubrication, and adjustment. this is a general guideline for maintaining your. Lubricate sterndrive and replace o rings (click to expand) frequency: every 100 hours. materials needed: bravo installation kit (16755q1), engine coupler spline grease (92 802869a1), u joint and gimbal bearing grease (92 802870a1), 2 4 c marine lubricant (92 802859a1), special lubricant 101 (92 802865a1) tools needed: rags; wire brush; grease. First, trim up the outdrive all the way and slide the drain pan underneath to catch the old oil. on 4.5l and 6.2l sterndrive models, remove the gear oil monitor cap to vent the system before using a flathead screwdriver to remove the upper vent screw on the outdrive. then, remove the lower drain screw and trim the outdrive down. Replace with new oil. inspect the raw water cooling system, checking impeller, cleaning strainer gauzes and removing salt from passageways. reassemble and paint. remove the prop, inspect it for damage and grease the shaft. align and lubricate the gimbal bearing, universal joint and drive shaft on re installation.
Comments are closed.