P0720 Output Speed Sensor Error Xoutpost The bmw part no. is 24341218551. you just need to drain the fluid & drop the sump pan – the sensor is held in by a single torx t27 screw & bracket. if you measure the resistance across the terminals it should read between 285 & 365 ohms. thanks for the great info. The ecu detects the slippage via the two speed sensors and drops into failsafe. similarly, if the transmission fails to engage either reverse (c & f clutch) or drive (a clutch) at tickover, but then slams the clutch(es) on when the engine revs are increased, this could also indicate that the additional pump flow produced by increasing the.
2006 Ford P0720 Output Speed Sensor Circuit Fault Youtube I get up to just about 70mph and my trans goes into failsafe and tosses a p0720 (output speed sensor) code. i'm happy to open the pan and change the sensor (pulse generator) but it started when the abs issue cropped up. As for now, i put it back in but did not yet connected it. started the car with difficulty, and in addition to p0720 code, it gave me p0335 code (crankshaft position censor circuit), connected the sensor, p0335 code disappeared. so that made me think that my p0720 code has nothing to do with the cps. This is a relatively simple process that involves disconnecting the old sensor and installing a new one. here are the steps you should follow: locate the output speed sensor. this sensor is usually located on the transmission housing. disconnect the electrical connector from the sensor. The fault code p0720 in an automobile can be caused by a few different factors. one possible cause is a faulty output speed sensor (oss). it could also be due to an open or shorted harness for the output speed sensor, or a poor electrical connection in the circuit. another potential cause is a faulty powertrain control module (pcm).
Comments are closed.