Rear Main Seal Installation Tip Seal Drivers Youtube Diy rear main seal installation tool. find a pipe cap or piece of pvc that fits the inside backside of your old seal. use the old seal as the drive surface o. The seal driver is simply electric tape wrapped around the shaft the seal goes on. clean any oil off of the shaft; in this case the inner fork tube. if the seal is a really tight fit, give yourself some room between the seal and the tape so you can slide hammer the seal (gently). i left about 4 inches between the seal and my tape wrap.
Rear Main Seal Installation Tool Driver Diy Youtube Just install it try. you just tap it in with a small hammer. take a light grit sandpaper, and sand the surface of the crank where the seal touches it. it needs to have a fresh bite surface for the seal to break in. put a little oil around the crank to lubricate the seal. I know that there is many different ways to install the rear main seal, such as flipping the old one around and using it, using a piece of wood, and all the other ways. i want to know if anyone has bought the tool, and where did they get it from. does any of the generic auto parts stores sell them, or is it a catolog order item. Perfect tool to drive in a new rear main seal! a couple of weeks ago i replaced my clutch, and while i had the engine out i replaced the rear main seal. i went hunting through my plumbing supplies to find something suitable to driving the new seal in, and found the perfect thing: a garbage disposal flange! it was the perfect size and drove it. Diy 7.3 rear main seal install tool. had a few days to kill before the rear main seal arrived and there was no way i was going to pay $250 for the tool so diy: driving compressing bolt is 5 8" 18 tpi. the two m12 bolts that bolts to the crank had to have their heads narrowed to clear the seal.
Comments are closed.