Ro System Installation Manual Replace housing on the ro system. 8. disconnect ro storage tank from the system. 9. ro storage tank cleaning procedure: a. the tank should be empty. check the air pre charge pressure with an accurate gauge (low pressure type 0 12 lbs). the average tank pressure should be 8 10 psi (when the tank is empty). b. Reverse osmosis system installation can be under a sink or in a basement. do not install unit where it would be exposed to freezing temperatures. connecting to an icemaker or other remote location can also be considered if a connection can be made without using more than 12″ of tubing, otherwise a delivery pump may be needed.
Reverse Osmosis System Installation Fermware The express water reverse osmosis system is designed to provide you with years of great tasting pure drinking water and trouble free service. since most of your system is already assembled, getting started is easy! read the installation manuals below for simple instructions on how to attach the color coded connections and get your system started. Installing the home master® reverse osmosis system 1. mount ro faucet* 1. use existing hole, or drill 1” hole in sink top. see page 3. 2. slide metal escutcheon plate onto faucet shank. 3. slide rubber washer onto faucet shank. 4. insert shank through hole in sink. 5. affix faucet to countertop with supplied wingnut, position faucet and tighten. 4 stage reverse osmosis systems model ro pure ® iom premier ro pure ro pure notice! warning read this manual before using this equipment. failure to read and follow all safety and use information can result in death, serious personal injury, property damage, or damage to the equipment. keep this manual for future reference. System tested and certified by nsf international against nsf ansi standards 42 & 58. see performance data on page 26 for details. manufactured and warranted by ecodyne water systems 1890 woodlane drive woodbury, mn 55125. 7322259 (rev l 11 21 14) product no. 8576162b.
Reverse Osmosis Manual Installation Innovateit 4 stage reverse osmosis systems model ro pure ® iom premier ro pure ro pure notice! warning read this manual before using this equipment. failure to read and follow all safety and use information can result in death, serious personal injury, property damage, or damage to the equipment. keep this manual for future reference. System tested and certified by nsf international against nsf ansi standards 42 & 58. see performance data on page 26 for details. manufactured and warranted by ecodyne water systems 1890 woodlane drive woodbury, mn 55125. 7322259 (rev l 11 21 14) product no. 8576162b. Turn on the cold water supply and tank valve. let the ro system run to re fill the tank (takes about 2 3 hours). 6) check for leaks! 7) drain the first tank of water (through faucet) to flush out the new membrane! the 2 tank of water is ready for use. Step 1 drill a hole into the sink for the faucet. notice: if your sink is equipped with a pre drilled 1 1⁄4” or 1 1⁄2” hole suitable for the faucet installation, you may skip to step 2. notice: manufacturer assumes no responsibility for damages resulting from installing faucets into any surface.
Comments are closed.